What Tampa Homeowners Should Know About the Shower Waterproofing Beneath Their Tile
Tampa, United States - November 20, 2026 / CMK Construction, Inc. /
Homeowners co-ordinating a home remodel often focus on tile and glass when planning a shower. Beneath the tile, a waterproof layer keeps water out of the wall framing and subfloor.
In this release, CMK Construction Inc. explains how shower waterproofing works and what Tampa homeowners can expect during installation.
Why Tampa Humidity Raises the Stakes Behind Tile
Water can seep through grout joints during normal use. If it reaches the framing, Tampa's humidity can slow drying. A musty smell that keeps returning, or grout cracks that reappear, can signal moisture or movement worth checking.
What a Remodeling Contractor Does Before Waterproofing Starts
A remodeling contractor starts by correcting framing problems and adding solid backing where needed. Built-in benches and recessed niches are two master bathroom ideas that affect where the backing goes and how crews waterproof the surrounding surfaces.
Crews then install the backer panels and prepare the shower pan, the sloped base that directs water toward the drain. Standard panels need a separate waterproof membrane, while waterproof panels form part of the barrier once crews seal their joints and pipe openings.
Building the Waterproof Layer as One Continuous Surface
CMK Construction Inc. installs the Schluter-KERDI system in every shower it builds. Its shower waterproofing forms one barrier across the walls and floor, with each part sealed to the next:
Membrane: Crews bond sheet membrane with thin-set mortar to the shower floor and, where needed, to the walls.
Seams: Crews overlap the sheets at the seams and seal them with waterproof strips.
Corners: Preformed pieces seal inside and outside corners.
Drain: The membrane bonds directly to the drain flange, sealing the connection at the shower floor.
Crews also seal openings around the shower valve and pipes, then check each seam and corner while the layer is exposed.
Testing the Shower Pan Before Tile Installation in Tampa
A remodeling contractor should flood-test the shower pan and drain connection before tile is set. Schluter recommends waiting at least 24 hours after membrane installation before beginning the flood test. Crews plug the drain and fill the pan, then leave the water in place, typically for a day or overnight. If the level drops, they investigate while the waterproofing is exposed.
Florida's residential building code sets a minimum for lined shower floors: water at least two inches deep, measured at the shower entrance, held for at least 15 minutes with no evidence of leakage. The company pulls a permit on every bathroom it remodels, so an inspector verifies the filled pan before tile is approved. That leaves Tampa homeowners with an inspection record.
Why a Remodeling Contractor Coordinates Every Trade
A remodeling contractor that manages every trade can keep the plumbing and waterproofing steps in order before tile is set. The company assigns a dedicated project manager to coordinate those trades on each job.
Its in-house plumbing team handles shower valve and drain work under the company's Florida plumbing contractor certification. Homeowners choose finishes at a 4,000-square-foot design showroom before construction begins.
About CMK Construction Inc.
CMK Construction Inc. is a family-owned remodeler that won Gold in the Bath Remodeler and Kitchen Remodeler categories of the 2026 Tampa Bay Best of the Best awards. Founded in 2004, the company also provides kitchen remodeling and roofing services. Homeowners planning shower waterproofing can schedule a consultation with the company.
Contact Information:
CMK Construction, Inc.
13329 West Hillsborough Avenue, Suite 104 Tampa, FL 33635
Tampa, FL 33635
United States
Manny & Courtney
https://www.cmkconstructioninc.com/